#Problem

REAL TIME CLOCK ERROR - CHECK DATE AND TIME SETTINGS

How to get rid of error “REAL TIME CLOCK ERROR - CHECK DATE AND TIME SETTINGS”

#Solution

Why this error?

This error usually means that your CMOS battery is dead and has no charge left. Since this CMOS battery is used to keep your system clock running when your system is turned off, you will get this error on every startup of your computer.

Ways to fix the startup error:

Procedure:

1. Power ON computer

When you first turn on your computer there should be a message saying something like "press F2 for setup".

2. Press F1/F2 for BIOS setup

Press it quickly. Every bios is a bit different, but if you navigate you should see a time setting.

3. GOTO Date/Time Option

Set it to the correct time as shown in picture

4. Press F10 to save changes and exit.

Validate and Fix Hardware:

The above steps do not work follow the CMOS battery replacement

1. Open your computer case and look for the CMOS battery.

2. Replace the battery. Close the case, plug in your computer, and start the computer.

3. Set the date and time if prompted.

[Important Note: You can contact me 9052312193, if you any challenges while performing mentioned actions]

#Problem

Step-by-step procedure to fix error “Windows can't be installed on drive 0 partition 1” while install Windows 10?

#Solution

Solve “Windows Can't be installed on drive 0 partition 1” error while install Windows 10. You can fix this error without any file loss if you do correctly otherwise it could happen, and you are trying to select another partition2 also showing same error “Windows can't be installed on drive 0 partition 2 error while install Windows 10”.

Can't select windows installation drive: error: Windows Can't be installed on drive partition.

Why this error?

[Windows Can't Be Installed on Drive and Partition?]

What is the way?

This error can occur when selecting an install drive after the first stage of Windows 10 installation process. If the partition you selected here is a local disk of a drive, the solution to this need to be done very careful. Other than that, if you are using a hard drive or SSD completely for Windows 10, then the solution can be done very fast, and simple.

Let me make it clearer.

Here you can see all the partition of the drive connected to the computer. If Operating system is installed on a Partition, commonly known as C drive of a HDD(Hard disk). Then the fix is only need to apply on that particular partition. And it’s essential to install windows 10 without damaging other partitions. For that, you need to do this procedure more carefully.

Let’s follow this procedure!

1. Power on the computer and press F10 key or hold the Shift key to enter into the Command prompt option.

2. Type the command “diskpart” and hit the enter key.

3. Type the command “list disk” (it will show all the connected disks.)

4. Type the command “select disk 0” à Disk 0 is now selected disk.

Important note: If you want to use the entire hard drive space for the Windows 10 operating system. From this point you can type the "clean" command and press the enter key. Then close the cmd (command prompt) and proceed to install windows 10.

(Following commands will helps you to save other partitions)

5. Type the command “list volume” à It will show all system partitions.